Process improvement software

Process improvement software you can use some alternative programs that will be used, such as Griffin, phoenix black box, tornado UFS, JAF, etc. But here I will use the N-BOX tornado as it is popular and easy to use. Before mobile phone repair must meet the requirements, as follows:

1. Battery voltage at least 3.7 Volt (siemens, Samsung, Motorola, and Sony Ericsson => because of type-type voltage is not provided directly by the UFS).
2. Short does not occur on the input voltage. Biloa occur shot must then be corrected before hardware, namely: resistansi check on the phone interface battery engine, 6 Ohm resistansinya maximum, then you flip polaritaskabel avometernya, the phone should show no movement occurs in the needle instructions.
3. Flash interface on the PCB must be clean. If dirty then you must first clear the brush and given a little thiner ago dried.
4. Once the phone is connected to the UFS tornado, after clicked "check" the phone must terdetek, diLCD although there are not any posts tesmode or local mode (especially Nokia). How to detect something like this:

• Use the program Ð DCTx tools
• connect the phone to UFS tornado
• Choose a type mobile phone according to the type of phone will be detected.
• Click on "check", DCTx tools will be the "1st Boot OK, WD2/DCT4, UPP: 0 ... ... ....." Error when the phone can not be detected by DCTx tools, then the damage is still on the hardware.

When tidah meet the requirements above then the damage is still possible in the hardware.